Frequently Asked Questions

Material price differences can be significant: PVDF is typically 30-60% more expensive than PP due to higher material cost and processing difficulty. Stainless steel and exotic alloys add further premium. Contact sales for exact pricing by model.

Key factors affecting magnetic pump price: material type (PVDF vs PP), motor brand and power rating, seal configuration, special certifications (ATEX, CE), custom specifications, and quantity ordered. Contact sales for detailed quotation.

Air volume adjustment range depends on control method: VFD typically provides 20-100% of rated speed (and corresponding volume); damper control can reduce volume further but with energy penalty. Practical turndown is limited by fan stall region on the performance curve.

Power adjustment methods: 1) Variable Frequency Drive (VFD) — most efficient, adjusts motor speed, 2) Inlet/outlet dampers — simple but less efficient, 3) Variable pitch blades — for large industrial fans, 4) Multiple fan staging — for variable load systems.

Filtration speed (face velocity) = Flow rate / Effective filtration area. Typically measured in m/min or m/h. Optimal velocity depends on filter media type and fluid properties. Exceeding recommended velocity causes increased pressure drop, reduced efficiency, and potential media bypass.

Noise control technologies include: acoustic insulation on fan housing, inlet/outlet silencers, vibration isolators for fan and motor, optimized blade design for reduced aerodynamic noise, speed reduction where possible, and acoustically lined ductwork.

Yes, filter screen material significantly impacts filtration effect. Different materials (PP, PE, nylon, stainless steel, PTFE) have varying pore structure, chemical compatibility, temperature resistance, and particle capture mechanisms. Material must match both fluid properties and filtration requirements.

Speed regulation methods significantly impact energy consumption: VFD (variable frequency drive) provides the best energy savings, reducing power proportionally to the cube of speed reduction. Damper control is less efficient as it wastes energy through restriction. VFD can save 20-50% energy at reduced loads.

Vertical pumps are suitable for: sumps and pits, underground storage tanks, wastewater lift stations, cooling towers, chemical tanks with limited floor space, deep well applications, and any installation where the liquid source is below ground level.

Cleaning cycle depends on: fluid contamination level, filtration precision rating, operating hours, and allowed pressure drop. Typical cycles range from daily for heavily contaminated fluids to monthly for clean applications. Monitor differential pressure to determine optimal timing.

For high-viscosity media: use larger pump sizing to compensate for reduced efficiency, select open or non-clog impeller designs, ensure suction piping is adequately sized to reduce inlet losses, operate at lower speeds, and verify motor has sufficient torque for viscous duty.

After long-term idling: 1) Inspect seals for drying or degradation, 2) Verify pump is primed (if self-priming), 3) Check for seized impeller from settled solids, 4) Lubricate if required, 5) Rotate shaft manually before startup, 6) Start at reduced speed if possible, 7) Monitor for unusual noise or vibration.