Customer Success Stories

The customer's three main problems—clogging, leakage, and self-priming failure—were closely connected:

• To prevent clogging, the impeller needs wide flow passages that can handle solid particles.

• To prevent leakage, the traditional shaft seal needs to be removed.

• To ensure reliable self-priming, the pump needs strong air-water separation and self-priming capability.

The main problem seemed to be that the pumps failed too often. But after a detailed review, we found that the real problem was the mismatch between the horizontal pump design and the scrubber operating conditions

The customer's main problem appeared to be "filter leakage," but a deeper analysis showed that leakage was only the visible symptom. The real causes were poor corrosion resistance of the filter housing, unreliable sealing, and insufficient filter element performance and service life.

After studying the customer's actual operating conditions, we found that this was a large-scale, high-requirement replacement project

After studying TESB's actual operating conditions, we found that the customer was facing more than a simple pump replacement problem. The reliability of the pre-treatment line depends on both tank liquid circulation and fume exhaust. If either system fails, the production line may have to stop. More importantly, the workshop contains both alkaline vapor and acid mist at different stages, so all equipment in contact with the process environment needs strong corrosion resistance.

After reviewing the customer's operating conditions, Meibao found that the problem was not simply about replacing one pump with another.

After reviewing AAL's actual operating conditions, Meibao identified three key requirements:Keep the motor away from acid fumes. Prevent shaft-seal leakage. Maintain stable operation when the tank level changes.